fmp 3d modeling

Mr.Bill · Post by **Mr.Bill** » Mon Sep 01, 2003 2:32 am

hey I want to model some stuff for ttf but I cant find any good shots , and by good I mean stuff I can use as an image plane (ie) a front and side view , no angled shots , just dead front , and dead side .... but I cant find any ,and I am not talented enough to draw them myself

HELLFIRE · Post by **HELLFIRE** » Mon Sep 01, 2003 2:43 am

Exactly WHAT is it you want to model there MrBill? The equipment, or...
And by TTF, do you mean TrueType Fonts? Sorry, reread your post
several times, but it doesn't quite make sense

Regards

Mr.Bill · Post by **Mr.Bill** » Mon Sep 01, 2003 2:44 am

I was thinking some arm slaves and some charecters

HELLFIRE · Post by **HELLFIRE** » Mon Sep 01, 2003 2:48 am

If you could get good front and profile shots of the chars, I know
you can either spline or nurb-model the chars faces, though it'd
be pretty tricky.

As for the mechs, you'd need some VERY detailed shots of the mechas
themselves, and they're not easy to come by

Regards

Mr.Bill · Post by **Mr.Bill** » Mon Sep 01, 2003 2:50 am

alls I need is a front , side ,and perspective shot to make an acurate model

Arx-7 Arbalest · Post by **Arx-7 Arbalest** » Mon Sep 01, 2003 7:58 am

try the manga......

darkbane · Post by **darkbane** » Tue Sep 09, 2003 12:05 pm

uh.. hope it's ok to post to an older thread. i dunno if you know it, but there's some front/side/back/perspective shots of some of the chars, unfortunately not any front/side of the mechas, over at http://www.full-metal-panic.com under the RECON section label. some are a bit skewed, but i think kaname's, souske's, and tessa's shots would be just about suitable.